Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Salt Lake City?
Spring repair in Salt Lake City typically runs $180 – $340 for one torsion spring, and most doors carry a matched pair that’s normally replaced together, so a two-spring job lands around $360 – $680. That covers the spring, the labor, and balancing the door. Cables, rollers, and bearings get checked at the same time because a worn spring usually means the surrounding hardware is working harder than it should.
We’re Cypress Garage Door Service, a garage-door-only shop, and we work on the system that’s already on your house: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Our technicians have up to experience. Call (866) 389-4585 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- One torsion spring replacement: $180 – $340 typical in Salt Lake City.
- A matched pair, the usual case: roughly double that, $360 – $680.
- Extension springs on older doors sit at the lower end of the range; heavy custom doors at the higher end.
- The written estimate sets the final price, and the estimate itself is free.
- A broken spring is a safety issue. Don’t run the opener until it’s looked at by a trained technician.
Spring Replacement Cost Breakdown (2026)
Here’s how a spring job breaks down by line item. These are typical estimated ranges for the Salt Lake City market in 2026, not a quote.
| Line item | Typical estimated range |
|---|---|
| Single torsion spring replacement | $180 – $340 |
| Matched pair, replaced together | $360 – $680 |
| Extension spring replacement (each) | $180 – $340 |
| Spring repair as part of a broader garage door repair | $150 – $600 |
| Cable repair while we’re in there | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| Opener repair if the motor took the hit | $120 – $320 |
| New door installation if the whole unit is beyond saving | $700 – $2200 |
What nudges the price up or down? The biggest factor is spring type. Torsion springs, which mount on a bar above the door, live at the top of the range; extension springs, which run along the tracks on older doors, tend to sit lower. The weight of the door matters just as much. A standard single-car door with a light aluminum panel needs a lighter spring than a double-car door with a thick insulated panel, and that spring costs more. If the door is out of balance after the spring is swapped, that adjustment is part of a proper repair, not a separate line item. If cables got chewed up when the spring let go, you’ll see the cable repair range added to the bill.
What Affects Spring Replacement Pricing in Salt Lake City
Salt Lake City has its own set of factors that affect what a spring job costs here, and they’re different from what you’d see in a milder, more humid market.
- Dry air and wood movement. Utah’s low humidity in summer and fall means wood door frames and jambs shift and dry out. When the frame moves, the torsion bar and spring anchors can get out of alignment, so a spring replacement here sometimes includes a track and balance check that a wetter climate wouldn’t need.
- Cold snaps along the Wasatch Front. Springs don’t like the swing from below freezing to warm. The steel fatigues faster when the door is cycled in cold, and a spring that’s been through several hard winters in Sugar House or the Avenues often breaks before it hits its rated cycle count. That’s one reason spring replacement is one of the most common repairs we handle in Salt Lake City.
- Spring type and door weight. Heavy double doors with insulated steel or wood panels need stronger springs, which cost more. Older homes in areas like the Rose Park and Glendale neighborhoods still have extension spring setups; newer construction in Daybreak and the west-side subdivisions almost always uses torsion springs. The two don’t price the same.
- High-cycle vs. standard springs. Standard springs are rated for a set number of door cycles. High-cycle springs cost more up front but last longer, and for a home where the garage is the front door and gets used a dozen times a day, the upgrade often pays for itself.
- Access and anchor condition. If the spring anchors look questionable, the technician has to address them, and that changes the scope. So does a garage with low clearance or a door that’s been patched together over the years.
- Whether the opener survived the snap. When a spring breaks under load, the full weight of the door can come down on the opener’s carriage and gear. If that happened, you’ll see opener repair added to the spring cost. We service chain, belt, screw, and direct-drive systems, including LiftMaster and Chamberlain myQ units and older Craftsman models.
How to Save on Spring Replacement
A few practical ways to keep the bill down, in order of how much they typically help.
- Replace both springs at once. A single spring breaks because both springs were installed at the same time and have lived the same life. Replacing one now almost always means replacing the other in a few months, and doing it as one job avoids paying twice for the labor portion. A pair costs more than one spring, but less than two separate visits.
- Ask about high-cycle springs. For a busy household, a higher-cycle spring can outlast a standard one by a wide margin, which lowers the cost per year even though the up-front price is higher. It’s a fair question to ask on any spring job.
- Bundle related repairs. If the rollers are flat-spotted or the cables are frayed, addressing them while the door is already apart saves a future callout. It’s also a safety issue, since old cables and springs fail together.
- Get a free estimate first. We write a free estimate before any work begins, so you know the scope and the price up front. Call (866) 389-4585 to schedule one.
- Don’t run the door on a broken spring. It’s tempting to keep using the opener, but a spring that’s snapped under load is genuinely dangerous, and the opener will strain against a door it can’t lift. That’s how you turn a spring job into a spring plus opener job.
Why the Spring Type on Your Door Matters
Two doors on the same block can take very different springs. Torsion springs mount on a horizontal bar above the door opening and come in pairs; a broken one usually means the other is close behind. Extension springs stretch above the tracks on each side and are common on older homes across Salt Lake City. Both do the same job, which is to balance the door’s weight so the opener only has to nudge it. When the spring lets go, the door becomes heavy enough that the opener can be damaged trying to move it, so the type on your door is the first thing a technician checks. We stock and order springs for the brands we work on, including Clopay, Amarr, Wayne Dalton, and Raynor, so the exact spring for your door’s make and weight is the one that gets installed rather than a generic workaround.
Can you replace a garage door spring the same day?
Yes, in most cases. Spring replacement in Salt Lake City is usually a same-day repair. When you call, we’ll get the spring type, door size, and brand so the right spring is ready when the technician arrives, and most jobs are done in a single visit. Call (866) 389-4585. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Is it cheaper to repair or replace a garage door spring?
Repair is nearly always cheaper than replacing the door. Spring replacement runs $180 – $340 for one spring, while a full new door installation starts at $700 – $2200. Replacing the door only makes sense when the panels, tracks, and structure are beyond repair, which is rare for a spring failure on an otherwise sound door. Call (866) 389-4585 for a free estimate so you know which case you’re in.
Why do garage door springs break in Salt Lake City?
They break from fatigue: a spring is rated for a set number of cycles, and the dry air plus the cold snaps along the Wasatch Front make the steel work harder than it would in a milder climate. Every open and close counts as one cycle, and in a household where the garage is the main entrance, it adds up fast. The spring was always going to break; the local climate tends to make it happen sooner. Call (866) 389-4585 to schedule a replacement.
Can I replace a garage door spring myself?
Not safely. A torsion spring stores enough energy to cause serious injury if it releases while you’re working on it, and the standard wrenches and winding bars are not something to improvise. We don’t walk homeowners through it, and neither should anyone else who’s honest. This is a job for a trained technician with the right tools. Our technicians have up to experience. Call (866) 389-4585 for a free estimate.
Do I need a permit to replace a garage door spring in Salt Lake City?
Spring replacement on an existing door generally doesn’t need a permit; a full door replacement or structural work often does, so it’s worth confirming with Salt Lake City’s building department before any bigger job. For a spring-only repair, the main requirement is a proper match of spring to door weight and a safe installation. Call (866) 389-4585 and we’ll tell you whether your job is likely to need a permit.
Related Garage Door Services in Salt Lake City
Springs are only part of the system. If your door is also making noise, running rough, or one panel is dented, we handle that too. We keep all three core services in-house: garage door repair, opener repair, and full installation. That means one call for the spring, the opener, and the panel, instead of finding a second company halfway through. We cover chain, belt, screw, and direct-drive openers, including LiftMaster and Chamberlain’s myQ ecosystem and older Craftsman units. If the opener is what gave out, we repair or replace it; if the door itself is the problem, we fix or install.
Spring replacement sits inside the broader garage door repair service. Cables, rollers, and tracks are usually part of the same visit, and each is priced on its own. Our Salt Lake City page covers the neighborhoods we serve and the kinds of jobs that come up here.
Contact
Call (866) 389-4585 for a free estimate on spring replacement in Salt Lake City. We’ll ask about the door’s brand and size, the spring type, and what happened when it broke, then get a technician out with the right spring. If you’re not sure whether the spring or the opener failed, we’ll figure that out on the call. Our technicians have up to experience, and we work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Salt Lake City market as of 2026. Cypress Garage Door Service offers free estimates – call (866) 389-4585.
Written by the team at Cypress Garage Door Service.
What Our Customers Say
"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Travis Ziegler"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Laura Hoffman"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Michael Barrett